Tag Archives: Water Heater

Simple Hacks to Properly Maintain a Water Heater

Water Heater MaintenanceOnly a few homeowners in Salt Lake City are keen to keep their water heater running efficiently, so the equipment will last longer. Though it can be time-consuming, it’s important to follow the maintenance procedures. This article shares the things you should not overlook.

Routine Maintenance

Every homeowner must be aware that the water heater tank gets dirty over time, as various minerals and sediments stay on the bottom. Depending on the water quality, the “extra” stuff can quickly eliminate the water heater’s efficiency.

If left unnoticed, they not only make the water heater work twice harder, but they also make the tank rusty. It will be then slowly eaten away until the entire unit becomes in need of replacement. This is very costly but can actually be prevented. How? You just need a bucket, a hose, and gloves for safety.

Reminders

To do a simple regular draining of water heater to keep it in good condition, remember that you need to know where the actual heater is. This could be very easy but tricky for non-experts. Most of the time, it is located in your garage. Be cautious, though. You will be dealing with electricity, gas, steam and very hot water. One mistake might mess up the whole system.

Prevention

There are many simple ways to increase a water heater’s operating durability and efficiency. You may add insulation and set the temperature. But this has to be done once only. Flushing the tank and checking of the anode rod, on the other hand, must be done annually.

The advantages of water heater maintenance are undeniable but remember that sole efforts to maintain your equipment can be dangerous. It is still advisable to ask for the services of experts in cleaning and maintaining water heater in Salt Lake City especially if you are a newbie.

How to Tell if Your Water Heater Needs Repair

Water Heater Repair

Water Heater Repair in Salt Lake CityEveryone has had an appliance break on them unexpectedly, but few things pose as huge of an inconvenience as a broken water heater. This is especially true during the winter months, when taking a bath in the freezing cold water is probably the last thing you want to do. As fixing it can take a while, you may have no choice but to tough it out for a few days.

Heaters don’t just suddenly malfunction, though. They gradually accumulate damage over their lifespans; lack of maintenance, internal rusting, sediment buildup, and excessively high water pressure are a few common contributors. If you don’t take care of your water heater, it shouldn’t be a surprise if the unit breaks.

How do you tell if this is about to happen? If you notice any of the following signs, it might be time to preemptively call a water heater repair service in Salt Lake City to help you out.

1. Corrosion – Rust and corrosion are often the most visible signs of heater damage. Look around the outside of the tank for it and see if the water is starting to become discolored; this would mean that the rust is seeping into the tank’s supply.

2. Leaking – Is water constantly leaking from your heater from places where it shouldn’t? This is usually a symptom of internal damage. Repairs are possible, but not always. You should immediately call a plumber to find out if it needs to be replaced.

3. Erratic heating – One of the telltale signs of a broken heater is an unexplained change in its temperature control. Perhaps the water isn’t as hot as it used to be on the same setting, or it changes randomly. Sometimes, it just doesn’t heat the water at all.

4. Age – You should keep in mind that the older a heater is, the more likely it is to develop problems. Even with meticulous care, there comes a time when buying a new heater is more practical and cost effective than continuing to maintain your current one.

Remember, prevention is better than cure. Taking good care of your water heater will make the difference between needing to replace a few parts and being forced to buy a new one entirely.